8-channel analog signal to RS485/232 converter (A/D Converter) has single-channel and 8-channel two kypes --made in Shenzhen Jieshengda techonology , China
JSD81 A0□- V(I)□ - □Communication interface
Input Voltage or Current Signal code
V1:0-5V485: Output is RS-485 interface
232: Output is RS-232 interface
Sample 1: model: JSD81 A08-I4-485 8-CH 4-20mA input signal,output is RS485 interface
Sample 2: model: JSD81 A08-V1-232 8-CH 0-5V input signal,output is RS232 interface
Sample 3: model: JSD81 A08-V2-485 8-CH 0-10V input signal,output is RS232 interface
8-channel analog signal to RS485/232 converter features:
● 8-CH analog signal acquisition/ isolation ,RS-485/232 output
● 24-bit AD converter, testing accuracy>0.05%
● Can Program and calibrate modules accuracy via RS-485/232 interface
● Input/output isolation: 3000VDC
● Wide power supply: 8~32VDC
● High reliability, easy programming and installation.
● Can program setting module address, baud rate
● Supports Modbus RTU protocol
● Low cost, small size ,SMD chip process design
analog signal to RS485/232 converter Typical Applications:
● Signal measurement/monitoring/control
● RS-485 remote I / O, data acquisition
● Intelligent building control, security engineering and other applications
● RS-232/485 bus industrial automation control system
● Industrial field signal isolation and long-term transmission
● Monitoring equipment operation
● sensor signal measurement
● Industrial field signal data acquisition and recording
● Medical, industrial product development
● 4-20mA or 0-5V signal acquisition
analog signals toRS485/232 converter (A/D converter)General Description:
JSD81 series products realize the signal acquisition between sensor and host, to measure analog signals. JSD81 products can be applied to RS-232/485 bus industrial automation control system,4-20mA / 0-5V signal measurement, monitoring and control,0-75mV ,0-100mV and other small-signal measurement and signal isolation and long-term industrial transmission and so on.
Products include power supply isolation, signal isolation, linearization, A/D conversion and RS-485 serial communication. Each serial interface can connect up to 255 pieces JSD81 series modules, communication using ASCII code or MODBUS RTU communication protocol, and its instruction set compatible with the ADAM modules, baud rate can be set by the code, with other manufacturers control module hang in the same RS-485 bus for easy programming.
1．"NC" pin must not be connected to any external circuit, or it will damage the product itself;
2. Please read the user manual carefully before using. If any question please contact our technical support department.
3. Please do not use this product in hazardous area. The power supply of this product should be 24VDC power source. It is forbidden to use 220VAC power supply.
4．Calculating from the date of delivery, during normal use of the product, any quality problems are free repair or replacement by Company during 3 years warranty.
5. To avoid invalid, or any failure, users disassemble this product is forbidden.